If you have any questions feel free to drop me a line.

Originating New Master Key

These procedures are if you are ordering the key Y160-PT.

Adding Duplicate Keys - Must have two valid programmed keys.

1. Insert one of the two valid programmed keys into the ignition cylinder and turn to the "ON" position.

2. After the inserted key has been in the "ON" position for at least five seconds, but no more than 15 seconds, turn the lock back to the "OFF" position.

3. Remove the key and Insert the second of the two valid programmed keys into the ignition cylinder and turn to the "ON" position with 15 seconds. (the second key must not be the same as the first key).

4. A theft alarm light should light after ten seconds, followed by a single chime sound indicating "Customer Programming Mode".

5. Turn the key to the "OFF" position within 60 seconds of the chime and remove the key.

6. Insert a new key into the ignition cylinder and turn to the "ON" position.

7. After approximately 10 seconds, a single chime will sound, and the theft alarm light will stop.

8. Wait five seconds, then turn to off position.

9. For additional keys repeat above steps.

BACK HOME

Back to the key store.